Respekta CH 24060 SAM Bedienungsanleitung Seite 168

WARNING: To guarantee adequate ventilation, remove the rear panel of the cabinet. It
is preferable to install the oven so that it is supported on two wooden battens. If the oven
rests on a solid flat surface, said surface must have an opening at the rear of at least
45×560 mm in size.
To secure the oven to the cabinet, open the oven door
and insert the 4 screws through the 4 holes in the edge
of the oven chassis.
CAUTION: All parts protecting against direct contact and insulated parts must be secured
so that they cannot be removed without the use of tools.
In compliance with statutory legislation, ensure that there is no risk of direct contact with
live electrical parts once the oven has been installed.
WARNING: The panels of adjacent kitchen units must be composed of heat resistant
material; in particular, units lined with plywood must be assembled with adhesives
capable of withstanding temperatures up to 100°C.
en-46
Fig. 5.6
Fig. 5.7