Installation Instructions Island Hoods - Respekta CH 44099 GISA Installations- Und Bedienungsanleitung

English
Read the general Instructions for use/operation carefully before mounting the cooker hoods
1 Preparations
1. Determine the exact location for the hood; ensure availability of the power
cable at the correct location.
2. The ceiling must support a load of at least 40 kg and be at least 40 mm
thick.
3. The ceiling must be aligned perpendicularly to the cooker hood installation
location. Deviations in excess of 1.5 mm must be compensated by suitable
construction measures to prevent the hood from hanging askew from the
ceiling.
4. A ceiling core drilling diameter 170 mm must be available before installing
the hood.
5. An exhaust air pipe for connecting the exhaust air hose A (Fig.1) must be
available or fitted prior to the installation of the hood.
6. The exhaust air hose A (Fig. 1) is not supplied with all appliances.
Whatever the case it must be obtained prior to commencing the hood
installation.
7. Comply with the prescribed distance of the hood to the hob. (Fig. 1)
2 Installing the hood
1. Hold the mounting plate A (Fig. 2) against the wall at the appropriate
location and mark on the ceiling the screw holes and where necessary
the hose section B (Fig. 2).
2. Drill the holes marked on the wall and insert the plugs for fixing the
mounting plate.
For secure fixing of the mounting plate, use all the 6 x 40 mm flat head
screws supplied.
3. Make sure the area is absolutely free from drilling dust and building
waste.
4. Mount the exhaust air hose A (Fig. 1) to the on-site exhaust air pipe.
5. Place the mounting plate A (Fig. 2) with its hose cut-out over the
suspended xhaust air hose (see Fig. 3) and fix to the ceiling with the
screws C (Fig. 2) size 6 X 40 mm.
6. Fix a perforated angle bar A (Fig. 4) to each of the 4 corners of the
mounting plate. (Fig. 3) Use two M4 X 10 mm screws with nuts and
washers.
7. Calculate the required overall length of the angle bars:
Height of the hob from the kitchen floor
+ 65 cm up to max. 75 cm
+ 8 cm resp. height of the hood body
= hood mounting height D (Fig. 1)
Room height
- Hood mounting height
= required overall length of angle bars B (Fig.5)
fi160630aomNEG
17. Installation Instructions for Island Cooker Hood
Fig. 2
Fig. 3
Fig. 4
Fig. 5
11
Fig. 1
C
D
A
A
A
GB
B
A
B