Connection Of The Appliance To The Electrical Supply - Respekta CH 24060 SAM Bedienungsanleitung

5.5

Connection of the appliance to the electrical supply

Read the following information connecting the appliance (oven/hob) to the electrical supply:
DANGER: Do not use adapters, multiple sockets or extension leads to connect the
appliance to the electrical supply, to avoid the risk of overheating and fire. If the use
of such accessories is unavoidable, use exclusively adapters and extension leads in
compliance with the safety regulations in force; do not exceed the maximum current rating
for each single / multiple adapter or extension lead.
The power cable must not touch any parts subject to heating and must be routed in
such a way that there it is not subject to temperatures greater than 50°C in any point. If
necessary, protect the power cable with a suitable insulating sheath.
CAUTION: Modifications made to the home electrical system can be carried out
exclusively by a specialised technician.
If the appliance plug is not compatible with the electrical socket, replace the electrical
socket with the required type. This modification can be performed ONLY by a specialised
technician. The technician must also ensure that the cross section of the electrical wiring
is suitable in relation to the appliance power consumption.
WARNING: Installation and electrical connections must be carried out by a specialised
technician in compliance with the manufacturer's instructions and statutory safety
regulations.
WARNING: A specialised technician must check that the home electrical system is
compatible with the appliance power consumption. Check the values shown on the
appliance nameplate.
The appliance nameplate must never be removed.
WARNING: The appliance power supply must be connected via an all-pole isolation
switch/contactor in compliance with the local regulations in force.
WARNING: The power cable must be checked regularly.
If the power cable is damaged or must be replaced, this must be carried out only by a
specialised technician with suitable tools to avoid the risk of accidents.
WARNING: If the appliance is connected directly to the power supply, install an all-pole
isolation switch/contactor with a minimum contact gap of 3 mm.
WARNING: The installer must make sure the electrical connection is carried out correctly
in compliance with safety regulations.
WARNING: The appliance power cable must be connected to a suitable electrical socket
equipped with a protective earth connection. If in doubt concerning the earth connection,
consult a specialised technician.
en-47