Hob Installation Instructions - Respekta CH 24060 SAM Bedienungsanleitung

5.3

Hob installation instructions

5.3.1 Dimensions of the worktop cut-out
Cut an opening in the worktop in compliance with the dimensions shown in the diagram. For the
purposes of installation and use of the appliance, keep minimum clearance of 50 mm (X) around the
cut-out, as shown in the figure.
The worktop must be at least 30 mm thick. To avoid deformation of the worktop that may be caused
by radiant heat from the hob, use heat resistant material. Use the sealing tape as shown in the figure.
WARNING: The worktop material must be composed of impregnated wood or another
insulating material
H
X
B
Model
HS2200-26
WARNING: Make sure the hob is well ventilated and that the inlet and outlet air flows are
not obstructed.
Make sure the hob is always in good condition.
sealing tape
L
D
X
L (mm) W (mm) H (mm)
590 520
W
X
D (mm) A (mm)
50 46 560
X
A
Fig. 5.1
B (mm) X (mm)
490 50 minimum
en-41