HBM QuantumX CX27C Bedienungsanleitung Seite 8

Safety instructions
Maintenance and cleaning
The modules are maintenance-free. Note the following points when cleaning
the housing:
S Before cleaning, disconnect the module from all connections.
S Clean the housing with a soft, slightly damp (not wet!) cloth. You should
never use solvents, since they could damage the label on the front panel
and damage the display.
S When cleaning, ensure that no liquid gets into the module or connections.
General dangers of failing to follow the safety instructions
The module is a state of the art device and as such is fail­safe. The module
may give rise to residual dangers if it is inappropriately installed and operated
by untrained personnel. Any person instructed to carry out installation, start-up,
maintenance or repair of the module must have read and understood the oper­
ating manual and in particular the technical safety instructions.
Residual dangers
The scope of supply and performance of the module covers only a small area
of measurement technology. In addition, equipment planners, installers and
operators should plan, implement and respond to the safety engineering con­
siderations of measurement technology in such a way as to minimize residual
dangers. On-site regulations must be complied with at all times. There must be
reference to the residual dangers connected with measurement technology.
After making settings and carrying out activities that are password-protected,
you must make sure that any controls that may be connected remain in safe
condition until the switching performance of the module has been tested.
Working safely
Error messages should not be confirmed until after the cause of the error is
removed and there is no further danger.
6
A02720_04_X00_00 HBM: public
CX27C