Setup; Steps For Configuration The Quantumx System; Configuration Steps Of Twincat - HBM QuantumX CX27C Bedienungsanleitung

EtherCAT
6.3.1

Setup

For this example a single MX module (MX840B) is connected to CX27
(FireWire). For the configuration and TwinCAT (PLC) a PC with two Ethernet
interfaces is used. The first Ethernet interface of PC is only used for EtherCAT
and directly connected with EtherCAT IN of CX27 over RJ45 cable. The
second interface of PC is connected with one of Ethernet interfaces of CX27
and used for the configuration.
6.3.2

Steps for Configuration the QuantumX System

Detailed information can be found in the Operating Manual of the CX27 in
chapter 5.2
6.3.3

Configuration steps of TwinCAT 3

1. Install TwinCAT3
2. Restart PC
3. Connect CX27 Ethernet Port (front or rear) with your PC (Ethernet Port)
4. Move to "C:\TwinCAT\3.1\Config\Io\EtherCAT" and paste the included
"HBM_CX27.xml" (ESI file).
24
A02720_04_X00_00 HBM: public
CX27C