Configuration
Fig. 5.1
Reset the fieldbus
Fig. 5.2
Select fieldbus
5.2
Adjustment of isochronous data transmission
You must first configure the relevant module channels for isochronous data
transmission with the MX Assistant ("Signals" tab) and via Ethernet TCP/IP:
1. Connect your modules in the deactivated state to the CX27 gateway via
FireWire cable 1-KAB272 (from connection X102 to X101, etc.), or use an
active backplane (BPX) for the connection.
2. Connect your PC to the CX27 gateway via an Ethernet cable.
16
A02720_04_X00_00 HBM: public
CX27C