Safety Instructions - HBM QuantumX CX27C Bedienungsanleitung

Safety instructions

1 Safety instructions
Intended use
The module and the measurement modules and transducers connected to it
must only be used for measurements and directly related control and regulation
tasks. Any other use is not the intended use.
In the interests of safety, the module must only be used as described in the
operating manual. When the module is in use, it is essential to comply with the
applicable legal and safety requirements for the relevant application. The same
applies to the use of accessories.
Before starting up the module for the first time, you must first run a project
planning and risk analysis that takes into account all the safety aspects of auto­
mation technology. This particularly concerns personal and machine protection.
Additional safety precautions must be taken in plants where malfunctions could
cause major damage, loss of data or even personal injury. If an error occurs,
these precautions will ensure that safe operating conditions have been estab­
lished.
This can be done, for example, by mechanical interlocking, fault messages,
limit value switches, etc.
4 CX27C
A02720_04_X00_00 HBM: public