Endress+Hauser Tankvision Multi Scan NXA83B Betriebsanleitung Seite 80

Konfiguration von DCC Slave
80
Bit Beschreibung erweiterter Messgerätestatus
0 Bottom Reference
1 Lower Sensor
2 Upper Sensor
3 Interlock
4 6280 = Master Enable
6290 = Medium Speed
5 Metric, 1 = metric, 0 = Imperial.
Note 6290 only
6 Drive Disable.
Note 6290 only
7 Disable Reel Alarm
8 Reel Alarm
9 Probe Uncalibrated
10 6280 = System Change Enabled
6290 = High Speed
11 Interval Timer
12 Probe At Liquid Level
13 Unit Not Responding
14 Bit test/Alarm bit test mode.
Note 6290 only
15 Simulator mode.
Note 6290 only
Bit Beschreibung Messgerätemodus
0 Manueller Modus
1 Calibrate Mode
2 Auto Mode (Follow Level)
3 Program Mode (Profile)
4 Drive Up
5 Stopped
6 Drive Down
7 Topscan Mode (Profile)
• ITG 60/70 Messgeräte
Bit Beschreibung erweiterter Messgerätestatus
0 Density Sensor
1 Temperature Sensor
2 BSW Sensor
3 Datum Sensor
4 –
5 –
6 –
7 –
8 1 Minute Warning
Tankvision Multi Scan NXA83B
Endress+Hauser