Inhaltsverzeichnis
Werbung
ENGINE OIL LEVEL INSPECTION
ENGINE OIL LEVEL INSPECTION
1. Stand the machine on a level surface.
NOTE:
• When checking the oil level make sure that
• Place the machine on a suitable stand.
Never remove the oil tank cap just after
high speed operation. The heated oil could
spurt out. causing danger. Wait until the oil
cools down to approximately 70 °C (158 °F).
2. Idle the engine more than 3 minutes while
3. Remove:
4. Inspect:
NOTE:
When inspecting the oil level, do not screw the
oil level gauge into the oil tank.
Insert the gauge lightly.
3 - 14
the machine is upright.
WARNING
keeping the machine upright. Then stop the
engine and inspect the oil level.
• Oil tank plug 1
• Oil level
Check that the engine oil is above the
level mark a and that the oil does not
come out when the check bolt 1 is
removed.
Below the level mark a → Add oil
through the filler cap hole until it is above
the level mark a.
Oil comes out at the check bolt → Drain
the oil until it stops coming out.
INSP
ADJ
Werbung
Inhaltsverzeichnis
