Maintenance; Safety; Preparation - Optimum OPTIdrill DH 40G Betriebsanleitung

6

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the geared drill.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the geared drill and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
During work on the spindle head, please make sure that

collecting containers with sufficient capacity for the amount of liquid to be collected
are used.

Liquids and oils should not be split on the ground.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current environmental protection regulations.
Collect leakages
Do not re-introduce liquids spilt outside the system during repair or as a result of leakage from
the reserve tank; collect them in a collecting container for disposal.
Disposal
Never dump oil or other environmentally hazardous substances which are harmful to the envi-
ronment in water inlets, rivers or channels.
Used oils must be delivered to a collection centre. Please consult your supervisor for further
information on your nearest collection point.
6.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

extremely serious injuries to those working on the geared drill and

damage to the geared drill.
Only qualified personnel should carry out maintenance and repair work on the geared
drill.
6.1.1

Preparation

WARNING!
Only work on the geared drill if it has been disconnected from the power supply.
Disconnecting and securing the geared drill on page 58
Attach a warning label.
Maintenance
Version 1.0.1 - 2020-11-24 Translation of original instructions

DH40G | DH40GP EN
79