Connecting The Rs232 Interface; Connecting An Rs232 Interface - Endress+Hauser asp-station 2000 Betriebsanleitung

4 Wiring
70
4.1.6 Connecting the RS232 interface (standard)
The standard version contains an RS232 as a service interface. Remove the controller
as follows.
1. Loosen the
fixing screws.
3. RS232 plug
behind front panel.
Fig. 11: Connecting a standard RS232 (interface behind controller)
A PC (9-pin SUB-D plug) is connected to the connection socket (3.5 mm, jack socket)
for the RS232 digital interface using the RS232 interface cable (3.5 mm, jack plug). The
Endress+Hauser device software ReadWin 2000 allows remote configuration and
measuring data polls.
Screened wire
Fig. 12: Pin assignment of RS232 interface cable
4.1.7 Connecting an RS232 interface (option -> see Fig. 2,
item g)
The ASP station 2000 is optionally available with an outer RS232 interface.
RS232 interface
on front panel
Fig. 13: Connecting RS232 option with outer interface
n.c. 1
1
2
2
3
3
n.c. 4
5
n.c.
6
n.c. 7
8
n.c. 9
9-pin socket
ASP station 2000
2. Pull the controller
forwards.
RxD
TxD
Gnd
Endress+Hauser