Mounting The Cover; Mounting The Rear Panel; Terminal Assignment - Endress+Hauser asp-station 2000 Betriebsanleitung

4 Wiring
!
68
Note!
The terminal connection is in a protected position beneath the cabinet cover in the
electronics compartment. Therefore to connect the power supply, you must remove the
rear panel and the cover of the device before commissioning. To install the rear panel
and the cover, proceed in reverse order to the descriptions in the following two sections.
4.1.3

Mounting the cover

1. Loosen the fixing
screws.
Fig. 7: Mounting the cover
4.1.4

Mounting the rear panel

1. Loosen the fixing
screws.
Fig. 8: Mounting the rear panel
4.1.5

Terminal assignment

Fig. 9: Position of the terminal board in the electronics compartment
2. Lift the cabinet
cover at the front.
2. Lift the rear panel up and remove it.
ASP station 2000
3. Pull the cabinet
cover forwards and
lift.
Endress+Hauser