Emissions - Optimum OPTIdrill DH 40G Betriebsanleitung

Spindle - Foot maximum distance
Working surface stand [mm]
Length x Width of the working surface
Rotatable drilling table
Dimensions of the machine
Required space
Total weight [kg]
Spindle speeds [ rpm ]
Gear stages / motor stages
Automatic spindle sleeve feed
Environmental conditions temperature
Environmental conditions of rel. humid-
ity
Gear operating material
Operating material
Toothed rod and drill column
2.1

Emissions

CAUTION!
The user must wear noise protection and hearing protection.
The A-weighted sound pressure level L
The A-weighted sound power level L
INFORMATION
This numerical value was measured on a new machine at a speed of 3200 rpm in one meter
distance under intended operating conditions. The noise behaviour of the machine might
change depending on the age and wear of the machine.
Furthermore, the noise emission also depends on production engineering factors, e.g. speed,
material and clamping conditions.
INFORMATION
The following factors influence the actual degree of the noise exposure of the operator:
Characteristics of the working area, e.g. size of damping behaviour,

other noise sources, e.g. the number of machines,

other processes taking place in proximity and the period of time, during which the operator

is exposed to the noise.
Furthermore, it is possible that the admissible exposure level might be different from country to
country due to national regulations.
This information about the noise emission should, however, allow the operator of the machine
to more easily evaluate the hazards and risks.
Technical specification
Version 1.0.1 - 2020-11-24
DH40G
590 x 700 x 1760 mm
Keep a work area of at least one metre around the machine free for
operation and maintenance.
320
no
about 3 liters of oil ISO VG32
is 89 to 94 dB.
pA
is 104 to 109 dB.
WA
Translation of original instructions
DH40GP
1180 mm
640 x 450
360°
335
95 - 3200
6 / 2
0.1 - 0.26 mm/rev.
5 - 40 °C
25-80%

Lubricant on page 104
acid-free oil
DH40G | DH40GP EN
61