Fallback Lms Codes - behnke AT6 Anleitung

Fallback LMS codes:

Z001 PSTN (landline): If the supply voltage of the telephone line fails for longer than
the set duration (fallback alarm delay), an LMS message with the code Z001 "PSTN
missing" is sent.
Z002 After the supply voltage is restored and persists longer than the set duration, an
LMS message with the code Z002 "PSTN available again" is sent.
Z003 GSM: In case of RSSI below the limit value (5) for the set duration (fallback alarm
delay), an LMS message with code "Z003 GSM missing" is sent.
Z004 In case of RSSI above the limit value (5) for a duration longer than the set duration,
an LMS message with the code "Z004 GSM available again" is sent.
Z005 PSTN (landline): If no test alarm can be sent via PSTN (landline) (for example, no
answer, busy, no dial tone P100/acknowledgement) and if the fallback alarm is
active, an LMS message with code "Z005 Failure routine" is sent via PSTN (land-
line).
Z006 PSTN (landline): If an LMS message cannot be sent via the PSTN (landline) transmis-
sion path, the device will try to send it via the second GSM transmission path. Thus,
if no LMS message can be sent via this transmission path (for example, no answer,
busy, no dial tone P100/acknowledgement) and if the fallback alarm is active, an
LMS message with code "Z006 LSM failure" is sent via landline (PSTN).
Z007 GSM: If no test alarm can be sent via GSM (for example, no answer, busy, no dial
tone P100/acknowledgement) and if the fallback alarm is active, an LMS message
with code "Z007 Failure routine" is sent via GSM.
Z008 GSM: If an LMS message cannot be sent via the GSM transmission path, the device
will try to send it via the second transmission path. Thus, if no LMS message can be
sent via this transmission path (for example, no answer, busy, no dial tone P100/
acknowledgement and if the fallback alarm is active, an LMS message with code
"Z007 LMS failure" is sent via GSM.
Z009 If no dial tone is detected when trying to make an outgoing call on the landline, the
attempts via landline are immediately stopped so that the device can directly use
the GSM interface. If a call attempt is aborted due to a missing dial tone, an LMS
message is sent with code Z009.
Behnke AT6 manual
fAllBAck function
87