General Information; Disclaimer - behnke AT6 Anleitung

Behnke AT6 manual

generAl informAtion

1. GENERAL INFORMATION
The device uses state-of-the-art technology and
complies with recognized current standards
on safety-related devices. These installation
instructions must be followed by all technicians
involved with the equipment, whether during
installation or maintenance. It is imperative that
these installation instructions are accessible at
all times to the responsible installers, techni-
cians, and maintanance and servicing staff. The
prerequisite for the safe handling and trou-
ble-free operation of this system is knowledge
of the basic and special safety regulations in
materials-handling technology, especially in
elevator technology. The device may only be
used as intended. In particular, do not make
any unauthorized changes or add parts to the
device or to individual components.

Disclaimer

The manufacturer shall not be liable to the pur-
chaser of this product or any third party for any
damage, loss, expense or labor caused by acci-
dent, misuse of the product, improper instal-
lation or unauthorized alterations, repairs or
additions. Warranty services are also excluded
in such cases. The manufacturer accepts no
liability for misprints, oversights or changes.
54
Safety note!
This product may only be installed and con-
figured by appropriately trained staff who are
authorized to perform work on this device. This
quality product is aimed at the elevator indus-
try. It has been designed and manufactured for
the specified use only. When used for any other
purpose, the manufacturer must be notified in
advance.
It must not be modified or altered in any way
and must be installed and configured in strict
accordance with the procedures described in
this manual.
When installing and configuring this product,
pay close attention to all the relevant occupa-
tional safety requirements and
all equipment standards. After installation and
configuration, this product and the function
of the system should be fully tested to ensure
proper operation before the system is put into
use.
Requirements for regulations related to the
specific application may deviate from preset
values. The set parameters must be checked
and adjusted if necessary.
Electrical and electronic products may contain
materials, parts and units that can be hazard-
ous to the environment and health. Please
inform yourself about local regulations and
waste collection systems for electrical and elec-
tronic products and batteries. Proper disposal
of your old product will help prevent negative
consequences for the environment and human
health.