Terminal Block Overview; Connection For Optional Machine Room Telephone; Led Indicators - behnke AT6 Anleitung

Behnke AT6 manual
overvieW of the At6 diAlling unit
3.1.

Terminal block overview

A
A/B A/B

3.2. Connection for optional machine room telephone

For configuration and communication via a
local telephone. Can also be used for external
calls. Any standard analogue telephone with
tone dialling and RJ12 connector can be used.
To connect to a bus unit, lift and select the digit
(1 to 6) corresponding to the desired bus unit.
"0" must be dialled for an outgoing call (dialling
tone).
Reset
▸
Resets all alarms and/or cancels current call
(press once).
▸
Activates the display of the GSM signal
strength (press and hold for 3 seconds).
▸
Triggers the self test and battery test (press 3x
within 2 seconds to start or cancel).
58
B C
+–
BUS STATION BATTERY
= 12 VDC
= Ground
= BUS A
= BUS B
D
+– + –
RELAY 1

LED indicators

LED 1 indicates the power supply status
▸
Green light: Main power supply OK
▸ Flashes in red: Battery operated, emergency
light is powered by mains
▸
Red light: Battery operated, emergency light
is not supplied by mains
LED 2 indicates active alarm and battery status
▸
Light off: No active alarm and battery status
OK
▸
Quickly flashes in yellow: Alarm not reset
(active emergency call state)
▸
Flashes in red: Battery test is running
▸ Red light: Battery test negative or no battery
connected
E F
RELAY 2