behnke AT6 Anleitung Seite 79

*94* 1 to 8 #
*50* "Speak"
1 or #
*51* "Speak"
1 or #
*52* "Speak"
1 or #
*53* "Speak"
1 or #
*54* "Speak"
1 or #
*55* "Speak"
1 or #
*56* "Speak"
1 or #
*57* "Speak" 1
or #
*60* #
0 or 1 #
*61* #
0 or 1 #
Simulate message
Voice recordings
Announcement for cabin
Announcement for bus unit 1
Announcement for bus unit 2
Announcement for bus unit 3
Announcement for bus unit 4
Announcement for bus unit 5
Announcement for bus unit 6
Announcement of the fire alarm
Playing announcement 50
Enable/disable announcement
Playing announcement 51
Enable/disable announcement
configurAtion StepS
Simulates and triggers a selected fault
message.
1 = Emergency call (to stored destina-
tion phone numbers)
2 = Routine test (to stored destination
phone number)
3 = Battery error
4 = Microphone/speaker error
5 = Message during voice call
6 = Maintenance
7 = Power failure at dialling unit
8 = Emergency call button (continuous
trigger)
Telephone number of the alarm
receiver for monitoring.
This announcement is played to the
receiver when the respective bus unit
is triggered.
To check the announcement again
yourself press the "1" key. To exit and
save press "#".
This announcement is used in fire
mode.
To play the recorded announcement
50 just press "#".
Press "0" to deactivate or "1" and "#"
to activate.
To play the recorded announcement 51
just press "#".
Press "0" to deactivate or "1" and "#"
to activate.
Behnke AT6 manual
79