Start-Up - behnke AT6 Anleitung

Behnke AT6 manual

StArt-up

8. START-UP
Equip all planned intercom stations with suitable bus stations and connect them to
the control cabinet via the travelling cable.
When using GSM or LTE interface circuit boards: Check reception at the installation
site using a cell phone.
Install the Behnke SL6 dialling unit according to the installation instructions.
if necessary, connect optional inputs and outputs, antenna;
connect telephone line and/or insert SIM card;
(The device will not start until the 230 V are also connected)
LED 1 lights up green,
Sound sequence is emitted.
1 sound per
bus unit detected.
One increasing sound per address
per existing bus unit.
LED 3 flashes in green:
Connection OK
*
The AT6 dialling unit searches for bus stations connected to the bus. For each bus unit found, a beep is emitted to the dialer's
system speaker. The sounds are divided into 6 whole-tone intervals. If the played sequence skips a tone, the corresponding
addressed unit was not found or is not correctly addressed. Since at least one intercom station is required for connecting the cabin,
the simplest constellation should start with the first tone (the bus station for the cabin has factory address 1).
70
Connect bus line;
Connect battery.
Connect ground and 230 V
The tones and addresses
*
LED 3 flashes in red: no signal.
LED 3 lights up red: no dialling tone.
Ready for configuration!
No LED, no sound!
Fewer sounds than
bus units
used do not match!
No 230 V, or
dialling unit defective!
See
"Troubleshooting - Bus unit"
Check telephone line or SIM card and
signal level