behnke AT6 Anleitung Seite 83

*82* 0 to 9 #
*91* #
*93* 0 to 2 #
*96* 0 to 4 #
*97* 0 or 1 #
Device number
Change password
Fallback
RX level (reception)
Background compensation
configurAtion StepS
For device number 0 (default), the
dialling unit responds immediately.
The device numbers 1 to 9 are used
because they use the same telephone
line (or gateway). Parallel connec-
tions can only be configured remotely
once the device numbers have been
assigned.
Change password for remote configu-
ration. (default = 0000)
The fallback function can be used
if both a functional interface circuit
board (GSM or LTE) and a telephone
connection are available in parallel. In
this case it is defined here which line
should be used primarily and which
secondarily in case of failure.
0 = Disabled
(default, no fallback in case of failure)
1 = Priority PSTN
(first via landline)
2 = GSM/LTE priority
(first via radio)
Increases the received transmission
level. Used in case the volume of the
reception centre is too low.
0 = 0% (default)
1 = +25%
2 = +50%
3 = +75%
4 = + 100%
0 = off (default)
1 = on
Behnke AT6 manual
83