Led Display On Bus Unit; Function During Use; Differences In Display Mode; Default (Factory Setting Parameter *78* To 0) - behnke AT6 Anleitung

Behnke AT6 manual

led diSplAy on BuS unit

7. LED DISPLAY ON BUS UNIT

7.1. Function during use

In both operating modes, the yellow pictogram
lights up constantly as soon as the alarm button
is pressed. The green pictogram lights up if the
bus unit detects a voice at the other end of the

7.2. Differences in display mode

Default (factory setting parameter *78* to 0)

Emergency call state
inactive
Emergency call state
inactive
Emergency call state
inactive
Emergency call triggered
Emergency call triggered
Emergency call state active Telephone line OK
Emergency call state active Connection established
68
connection. The green pictogram will extinguish
automatically once the call is ended. The yellow
pictogram disappears when the active alarm is
terminated (reset button by the releaser, or key
tone 5 (MVF tone) by the remote station.
Telephone line OK
Telephone line not OK
Telephone line not OK
Telephone line OK
Telephone line OK
Intercom station OK
Intercom station OK
Intercom station not OK
Intercom station OK
Emergency call filter active
Intercom station OK
Intercom station active