Configuration; When Connecting To The Behnke Emergency Call Centre (Remote Configuration Via Modem); Configuration Using The "Safeline Pro" Program - behnke AT6 Anleitung

configurAtion

9. CONFIGURATION
9.1. When connecting to the Behnke emergency call centre (remote configuration
via modem)
Partners of the Behnke emergency call centre
report their assignment and emergency plans
by means of a standby contract directly to
the emergency call centre when ordering and
before start-up. On the start-up day, the service
department is notified of the installation and
the configuration is performed by the service
department via remote configuration. After
9.2. Configuration using the "SafeLine
Pro" program
The device can be configured in the call centre
before installation or on site after installation.
The "SafeLine Pro" configuration software can
be downloaded from the Internet. This requires
a serial or USB-based programming cable and a
mobile PC.
successful commissioning, the contract comes
into force.
For remote configuration, a "Safeline ProLink"
modem is used, which requires modem signals
as well as error-free transmission of DTMF tones
at the local telephone connection. Connections
via GSM or LTE are already suitably set up.
Behnke AT6 manual
configurAtion
71