Mounting; Mounting The Dialling Unit - behnke AT6 Anleitung

Behnke AT6 manual

mounting

5. MOUNTING

5.1. Mounting the dialling unit

Mount the dialling unit using suitable screws on
a solid surface (e.g. wall, control cabinet) in the
machine room or shaft head depending on the
application (see mounting instructions for GSM
and LTE). Terminating resistors at the bus ends
are not required.
Machine room
Elevator
62
For the connection of the bus units and the
elements of the elevator optionally connected
there (e.g. pictograms or emergency call
button), the 4 wires (orange, grey, brown and
blue) must be connected to terminal block B of
the dialling unit via the travelling cable.
If optional inputs or outputs at terminal block E
and D (e.g. horn, emergency light or relay) are
used, they must be connected directly to the
control unit or additionally via the travelling
cable
Optional for local pictograms and/or 12 V button
JST cable
Emergency call button
connection. Connection
cable 99-1066 is required
for this.
Yellow pictogram for entering
Green pictogram for entering
External key for entering
VOLUME
1 1
2 2
3 3