Operating The On-Screen Display At The Console; Showing The On-Screen Display At The Console - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Function
Changing the colour of the information display
Information display
Adjusting the transparency of the on-screen display
Automatic closing of the OSD after inactivity
Changing the position of the information dispaly
Changing the position of the on-screen display
The basic operation of the on-screen display (see page 26) and the web application
Config Panel (see page 29) is described on the following pages.

Operating the on-screen display at the console

The on-screen display (OSD) – just like the web application
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module. You can view and edit the settings of the KVM extender only in the remote
OSD of the computer module.
NOTE: Use the remote hotkey
ure the remote OSD of the computer module and the
to open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see Starting process on page 13).

Showing the on-screen display at the console

How to open the on-screen display:
1. Press Ctrl+Num (standard) to open the on-screen display.
(default: Ctrl + Num ) at the console to open and config-
Configuration
Default setting
light green
temporary
average transparency
disabled
left upper corner
centred
, which is
Config Panel
local hotkey (default:
G&D VisionXS-IP-C-DP-UHR · 26
Page
50
51
52
53
54
54
Alt + Num )