Operating The On-Screen Display At The Console; Showing The On-Screen Display At The Console; Layout Of The On-Screen Display - G&D DP-Vision-Fiber Installationanleitung Und Betriebsanleitung

Function
Changing the colour of the information display
Information display
Adjusting the transparency of the on-screen display
Changing the position of the information dispaly
Changing the position of the on-screen display
The basic operation of the on-screen display (see page 22) and the web application
Config Panel (see page 24) is described on the following pages.

Operating the on-screen display at the console

The on-screen display (OSD) – just like the web application
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module. You can view and edit the settings of the KVM extender only in the remote
OSD of the computer module.
NOTE: Use the
remote hotkey
ure the remote OSD of the computer module and the
to open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see Starting process on page 14).

Showing the on-screen display at the console

How to open the on-screen display:
1. Press Ctrl+Num (standard) to open the on-screen display.

Layout of the on-screen display

After pressing the hotkeys, the OSD is displayed on the console monitor:
Configuration
Console setup
Local console setup
Target setup
System setup
Network setup
Information
Target power
ESC
The on-screen display consists of three parts:
(default: + ) at the console to open and config-
Ctrl Num
Configuration
Default setting
light green
temporary
average transparency
left upper corner
centred
Config Panel
local hotkey (default:

...
...
...

...
...
...
turn off

G&D DP-Vision-Fiber · 22
Page
45
46
47
48
48
, which is
Alt + Num )