Year Of Manufacture; Service; Servicing Report; Spare Parts - probst HVZ-ECO Betriebsanleitung

HYDRAULIC ROTATORS
GB
The extraction of the pins may cause unpredictable
movements in the structural work: immobilise the parts
before performing any operation.
Use only original spare parts.
For spare parts orders, please specify:
- MODEL
- SERIAL NO.
- YEAR OF MANUFACTURE
To be performed every 500 working hours:
- verify that the play between pin and bush is less than
0.6 mm; if greater, replace the worn parts;
- check the seal of the cylinder gaskets and replace if
necessary;
- check the condition of the hoses and replace if
necessary;
- check the condition of the metal structure, if
necessary replace the damaged parts;
- check the tightness and condition of the pin locking
nuts and the bolts joints;
- check that the equipment is working properly.

9.3 Service

For any repairs or overhauls, contact FERRARI
INTERNATIONAL S.p.A. so we can provide qualified
personnel and suitable tools.
We also offer technical service at our headquarters for
any information, advice, and indications on authorised
service centres.

9.4 Servicing report

9.4.2 Overhauls and repairs
All overhaul and repair operations must be recorded
on the maintenance record form. The specialised
technician in charge of these operations will prepare
a signed report, specifying the work carried out as
well as any modifications and/or deficiencies of the
equipment.
30

10. SPARE PARTS

To identify a spart part, follow the procedure described
below:
- Locate the part and its position number on the
specific drawing of the assembly.
- Consult the table and, in correspondence with the
position, find the information necessary for ordering
the part:
• Code
• Description of the part
• Quantities fitted on the machine (Qty)
- Complete the order form and FERRARI
INTERNATIONAL S.p.A. will supply the spare parts.
We recommend that you record in the manual the
periodic servicing operations and/or special
maintenance operations carried out so that, when
necessary, it will be faster and easier to find the
problems and therefore the most economical solution.
The equipment purchased must always be kept in
perfect working order. Therefore, when spare parts are
required it is indispensable to use only original spare
parts, requesting them directly from the manufacturer
or through your authorised dealer.
Applying spare parts of inferior quality may cause
damage to other components.
The positive outcome of the maintenance and overhaul
operations depends on the instructions and advice
suggested based on our experience.