Mounting The Motor - Bosch Rexroth CSS/B Betriebsanleitung

20/38 Bosch Rexroth AG
1. Remove the yellow protective
cap (X) from the shaft on the
new motor.
Grease the motor shaft.
Please note:
• The plane surfaces on the motor
and gear must be undamaged.
• The hub of the gear has already
been greased with 'Anti-Seize' at
the factory.
• Do not tilt the motor, make sure
there is enough clearance for
assembling the motor.
• Position the motor correctly
(terminal box!) and mount the
motor in the gear.
• If the motor is not properly
positioned: do NOT turn it.
Disconnect the motor from the
gear and assemble it again.
2. Assemble the motor.
6.10

Mounting the motor

1
Fig. 8 Mounting the motor
TS 2pv | 3 842 539 952/2011.02
2
(4x)
SW8
M = 5 Nm
D
X
539 952-15