Decommissioning; Disassembly And Exchange; Preparing The Belt Section Css/B, Css/Bm, Css/F, Css/Fm For Storage/Further Use - Bosch Rexroth CSS/B Betriebsanleitung

36/38 Bosch Rexroth AG
10

Decommissioning

The product is a component that does not have to be decommissioned.
As a result, this chapter in these instructions does not contain any
information.
How to disassemble and exchange the product is described in chapter 11
"Disassembly and Exchange" on page 36.
11

Disassembly and Exchange

WARNING
High electrical voltage!
Danger of severe injuries or death due to electric shock.
Make sure the relevant system component is not under pressure or
voltage before performing any maintenance or repair work.

Protect the system against being switched on.
High pneumatic pressure!
Danger of severe injuries or death.
Switch off the compressed air supply on the relevant system component
before performing any maintenance or repair work.

Protect the system against being switched on.
Lifted loads may fall!
Falling objects may result in severe injuries (or even death).

Always use lifting equipment with a suffi ciently high load bearing
capacity (see the shipping documents for product weight).

Before lifting the product, make sure that the carrying straps are
correctly fastened!

Secure the product to prevent toppling while lifting!

Make sure that no one is in the danger area when raising and
lowering, with the exception of the operator!
11.1 Preparing the belt section CSS/B, CSS/BM,
CSS/F, CSS/FM for storage/further use
• Only store the belt section on a fl at surface.
• For a belt section with an assembled motor:
Support the belt section so that there is no load on the motor.
• Protect the belt section against environmental infl uences such as
contamination and humidity.
• Protect the belt section against mechanical infl uences.
• Observe the environmental conditions.
TS 2pv | 3 842 539 952/2011.02