Recommissioning After Shutdowns; Operation; Notes On Operation - Bosch Rexroth CSS/B Betriebsanleitung

3 842 539 952/2011.02 | TS 2pv
7.3

Recommissioning after shutdowns

Follow the same procedure used for initial commissioning.
8

Operation

CAUTION
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 70°C) are touched

Provide appropriate safety devices to seal off the motors.

Let the system cool off for at least 30 min. before performing any
maintenance or repair work.
8.1

Notes on operation

8.1.1 Wear
• Wear is caused by the basic principle of this system and cannot be
avoided. Constructive measures and selection of the proper materials will
help functional safety last for the lifetime of the system. However, wear
depends on the operating, maintenance, and ambient conditions of the
system, as well as the location (resistance, contamination).
• Overloading the conveyor sections may damage the conveying medium
and cause the motor and gears to fail.
• Function cannot be guaranteed if the pneumatic components are
overloaded.
8.1.2 Measures to reduce wear
The following measures reduce wear:
• Switch off conveyor sections when the system is not running, e.g. during
breaks, over night, on the weekend.
• Only select speeds that correspond with the particular function.
• Especially important: Avoid contamination by abrasive media; reduce
contamination through regular cleaning.
Bosch Rexroth AG 27/38