Safety Instructions Related To The Product And Technology - Bosch Rexroth CSS/B Betriebsanleitung

8/38 Bosch Rexroth AG
During transport
During assembly
During commissioning
During operation
2.6 Safety instructions related to the product and
technology
General • Do not modify or convert the product.
• Do not expose the product to any mechanical loads under any
circumstances. Never use the product as a handle or step. Do not place
any objects on the product.
• Always secure the product to prevent toppling.
• Observe the transport instructions on the packaging.
• Lay cables and lines so that they cannot be damaged and no one can trip
over them.
• Make sure the relevant system component is not under pressure
or voltage before assembling the product or when connecting and
disconnecting plugs.
• Protect the system component against being switched on.
• Before commissioning, make sure that all seals and caps for the screwed
connections are correctly installed and undamaged to prevent fl uids and
foreign bodies from penetrating the product.
• Let the product acclimate itself for several hours before commissioning,
otherwise water may condense in the housing.
• Make sure that all electrical and pneumatic connections are either used
or covered.
• Check the safety requirements in accordance with DIN EN 619, 6.2, 6.3
and Appendix H.
• Commission the product only if it is installed completely.
• Make sure that all safety equipment belonging to the product is present,
has been installed properly, and is fully functional. Do not modify the
position of, bypass, or disable the safety equipment.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Ensure that only authorized personnel use the product within the scope of
its intended use
— Start or operate the system, or intervene in its normal functioning
— Activate adjustment devices on components.
• Only allow persons who are authorized by the system owner to access
the product's direct operating area. This also applies when the product is
standing still.
• Make sure that
— There are no obstacles preventing access to the emergency-off
switches.
— All delivery points, workstations and passages remain freely
accessible.
• Do not use the emergency-off switching device for routine stops.
• Regularly check the proper functioning of the emergency-off switching
device.
• In case of an emergency, fault, or any other anomalies, switch the
product off and protect it against being switched on again.
• Do not reach into moving parts.
• An idle system is not a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
TS 2pv | 3 842 539 952/2011.02