Legal Information; Trademarks - Ottobock Varos 5A60-Serie Gebrauchsanweisung

4) Pull the socket over the residual limb.
INFORMATION: In doing so, note the alignment of the toes and the position of the
lower leg so the desired level of exterior foot rotation is given while standing and
walking. If the exterior foot rotation is not correct, take the socket off again (at least,
the magnetic cap has to be released from the bottom of the socket) and put it back on
in a changed position.
→ The magnetic bottom shell of the socket and the magnetic cap of the liner attract each oth­
er when they are brought close together. A clicking sound is heard, indicating the proper
connection of the socket and liner.
5) Push the Boa dials towards the socket.
6) Turn the Boa dials clockwise.
→ The Boa cables are tightened and the socket is closed.
INFORMATION: Position the outer socket shell (lateral) under the inner socket
shell (medial).
7) Tighten the Boa dials as needed.
7.2 Taking off the socket and liner
1) Pull the Boa dials away from the socket.
2) Pull the outer socket shell (lateral) to the outside.
If plastic adhesive strips are used in the lateral socket shell, pull until there is no longer any
contact between the plastic adhesive strips and textile cover of the liner.
3) Push the socket off the residual limb.
In doing so, preferably grasp the socket brim of the lateral socket shell with one hand and the
socket brim of the medial socket shell with the other hand.
4) Unroll and remove the liner from the residual limb.
8 Cleaning
1) Clean the product with a damp cloth and mild soap (e.g. Ottobock 453H10=1 Derma Clean)
when needed.
2) Dry the product with a lint-free cloth and allow it to air dry fully.
9 Maintenance
► A visual inspection and functional test of the prosthetic components should be performed
after the first 30 days of use.
► Perform annual safety inspections (visual inspection for damage and wear and tear, functional
test).

10 Legal information

10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.

10.2 Trademarks

All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
43