Ottobock Varos 5A60-Serie Gebrauchsanweisung Seite 37

Threading the Boa cables
18
Complete the following steps to thread the Boa cables:
1) Thread the distal Boa cable into the cable guides on the medial socket shell (see fig. 18,
orange cable guide), producing the number of cable crossings specified in the table.
2) Thread the proximal Boa cable into the medial socket shell, initially on one side.
3) Insert the lateral socket shell into the medial socket shell.
4) Thread the proximal Boa cable into the cable guide above the dial housing (see fig. 18, red
cable guide).
5) Thread the proximal Boa cable into the medial socket shell on the second side.
6) Thread the two ends of the two Boa cables through the corresponding openings into the dial
housing.
Installing the Boa reels
19
22
Complete the following steps to install the Boa reel:
1) Thread one end of the proximal Boa cable through the bore marked in red (see fig. 19).
2) Fold over the cable end and thread it back through a parallel bore (see fig. 20).
3) Fold the cable end over again and insert it to the stop into a blind hole next to the bore
marked in red (see fig. 21).
INFORMATION: The Boa cable is secured against slipping out by means of self-lock­
ing due to the two sharp turns.
4) Tighten the two resulting cable loops (see fig. 22, see fig. 23).
20
23
21
24
37