Ottobock Varos 5A60-Serie Gebrauchsanweisung Seite 38

5) Perform the described steps for the second cable end on the opposite bore marked in red.
6) Carefully pull on the Boa cable on both sides of the Boa housing.
7) Lightly push the reel into the Boa housing with your finger (see fig. 24).
INFORMATION: The spur gearing on the reel still has to be visible after insertion,
which means it has to face out.
8) Repeat steps 1-7 for the second reel.
Installing the Boa dials
25
Complete the following steps to install the Boa dials:
► Install the Boa dials using the Boa tool.
INFORMATION: Make sure that the Boa dials are parallel to the socket shell.
INFORMATION: Take care to fully tighten the screws to the stop.
6.3.5 Installing the axle
26
Complete the following steps to install the axle:
1) Insert the connecting lugs of the lateral side rail into the medial side rail.
2) With a hammer, tap the axle into the bore in the medial and lateral side rails.
3) Use a cotter pin drive to tap the axle all the way in (see fig. 26).
INFORMATION: The axle is thicker at the end in the form of a knurling. This knurling
must only be tapped into the bore as the final step. This side is also marked with a
face end bore so the required removal direction can be determined if the axle has to
be removed later.
4) Tap the axle in until the end of the axle only just disappears into the bore.
If the axle has to be removed, the knurled end has to be pushed out of the bore first. To use the
medial side rail and axle again, the axle has to be installed into the medial side rail from the other
side the second time.
38