15. Installation of the intake silencer with integrated airfilter
Note:
Seite/page 68/100
Downloaded from
www.Manualslib.com
Operating Instructions 125 MAX DD2
Install rubber intake pipe (4) in a vertical position in the bottom half (2) of intake
silencer so that the rounded intake openings point outwards.
Fit the carburetor socket (5) into the inner side half of silencer (1) so that the arrow
on the socket points towards the carburetor.
Apply "Airfilter cleaning kit" ROTAX PN.: 297 160 (10) on the filter mat (3) and
squeeze out surplus oil afterwards.
Assemble the silencer components as shown in fig. 12 and make sure that the
locking is interlocked properly
Attach the intake silencer with the supplied hose clamps (6) on the carburetor.
The carburettor socket (5) is asymmetrical and can be turned so that the best
possible position between carburettor and intake silencer can be achieved.
manuals search engine
Fig. 12
Ausgabe/edition 01/2006