Kemper KHS Mini MASTER 2.1 Montage- Und Bedienungsanleitung Seite 168

EN
Status
LED
Max. number of
switching cycles
20,000/50,000/
disinfection limit
Set-point max.
limit exceeded
Set-point min.
limit undercut
Frost protection
limit undercut
Set-point OK
168 / 259 – K410068602008-00 / 09.2020 – © www.kemper-olpe.de
Description of warnings / notices
Error Possible cause
The quarter turn stop valve
on the defective SLAVE has
exceeded.
performed more than 20,000
operating cycles.
50,000
Thermal The monitored temperature
has exceeded the set limit
exceeded
The monitored temperature
has exceeded the set limit
The monitored temperature
has undercut the set limit
The monitored temperature
has undercut the set limit
Notice that the monitored
temperature is in the target
Control in No flushing pending. Control
standby in standby.
Flushing is The valve on the involved
running control is flushing / is open.
Measure
Warnings
Replace the quarter
turn stop valve bon-
net in accordance
with the maintenan-
ce manual and reset
the operating cycles.
Check to see if it
needs to be set
value. otherwise.
Check to see if it
needs to be set
value. otherwise.
Check to see if it
needs to be set
value. otherwise.
Prevent danger of
valves freezing up.
value.
Notes
No action needed!
range.
No action needed!
No action needed!
Effect
The warning message
cannot be confirmed.
SLAVE continues to
operate normally.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
No influence.
Entry in logbook.