Care Instructions; Heyner ® Capsula Multifix Ergo 3D / Heyner ® Capsula Multifix - Heyner Capsula MultiFix ERGO 3D Bedienanleitung

English
Customize the belt height adjuster in the vehicle to the size of the child and
size of the child car seat. Check the path of the belts and the headrest height
from time to time and adapt them to your growing child.
Please follow the instruction drawings and assembly details carefully.
If you have any questions, please contact your dealer,
the importer or the manufacturer.
2.4. Adjustment of the headrest to the size of your child
To adjust the height of the headrest (A) to the size of your child touch the headrest from the back
and pull the positioning handle (H) up. Now you can,
depending on the size of your child, adjust the head-
rest (A) to the desired height.
Once you have reached the correct height, release the
positioning handle (H) and the headrest (A) will click
into the desired height.
Caution! Adjust the diagonal and lap belt on the child
and pay attention to the correct belt run:
The diagonal belt should run in the middle of the shoulder, the lap belt as low as possible across
the groin. Make sure that the diagonal belt runs exactly, and passes not too close on the neck of
the child. All belts must lie fi rmly on the child and must not be twisted.
Between belts and the child's body may only fi t a fl at hand.
Adjust any belt height adjuster in a car to the size of the child and the child car seat. This headrest
has 7 diff erent adjusting positions. Check the run of the belts and the height of the headrest from
time to time and adjust them to the growing child.
29
Gurtführung Gurtführung
Gr. 2 Gr. 3

3. Care instructions

To wash the cover of your
HEYNER ® Capsula MultiFix ERGO 3D / HEYNER ® Capsula MultiFix
AERO push the seat part (ST) by using the positioning handle (PG),
which is under the central adjusting belt (G5), in the furthest reclined
position (lying position).
Release the safety lock (SR) of the safety bolt (SB) on the top of the back of the base (BT)
and pull the safety bolt (SB) sideways out of the base holes (BL). Now the seat part (ST) is
unlocked and can be clapped forward.
Release the belt ends of the harness belt (G2) on the back of the seat part (ST) from the belt
anchor (R) and pull out the two ends of the belts through the shoulder belt guides (G1).
Then unhook the shoulder pad belts (SG) from the connecting hook (VH).
The cover can now easily be removed through the crotch strap and washed at 30 ° C. Belts
and buckle must not be washed.
Please do not dash. Do not tumble dry. When upholstering the HEYNER child car seats look
again after the right anchoring of the harness belt (G2) in the belt anchor (R) as well as the
shoulder pad belts (SG) in the connecting hook (VH). Secure the right run of all belts. If you
feel insecure, take some photos BEFORE removing the parts.
English
GB
1
2
3 4
30