Care Instructions; Important Notices - Heyner capsula MT6 Bedienungsanleitung

English

4. Care instructions

To wash the seat cover you can simply peel off all covers.
BACKREST COVER REMOVAL: Release the elastic strap at the bottom
of the backrest cover, Slide the cover off. The covers can now be cleaned.
HEADREST, BOOSTER SEAT COVER REMOVAL: Slide the cover off. The covers can now be
cleaned.
Preferably, the cover should be washed with Hands. Use only a mild hand soap and
warm water. Do not use chemical cleaners and never attempt to bleach or dye
the webbing. Allow to dry naturally.
It is possible to wash the cover at 85ºF/30ºC in the washing machine.
Attention: Please do not spin. Do not dry in a dryer.
Attention: when again covering capsula
shoulder belts firmly correct on the belt anchorage (K) and don't twist the belt.
Attention The child restraint must not be used without the cover.
The seat cover should not be replaced without one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint
performance.
Don't use any car seat again after impact or accident.
Please remove the car seat out of vehicle when it is not used and keep out
reach of child.
Please always fasten the car seat when it is inside the vehicle.
Please always read the manual before use it, and the manual is locate in the
back of car seat, under the cover bag.
c -capsula.com
27
MT6 make sure, to fix the
®

5. Important notices

• capsula MT6 child seat is approved in accordance to the European
®
Standard for child restraint systems ECE R44/04. The test symbol as well as the permit
number can be found on the orange label on the back of the seat.
• This child seat is for generel use in vehicles and will fit most, but not all vehicle seats.
• A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook
that the vehicle is capable of accepting a „Universal" child restraint for this group.
• Using capsula MT6 for Group II+III, please guide the lap belt as close
®
as possible to the lap of your child, and keep the lap belt as tight as possible.
• This child seat can only be used in vehicles with three-point-vehicle-belts, static and
retractor, that are approved by the ECE regulation No. 16 or other comparable
standards. It is strictly forbidden to install this seat with the lap belt alone.
• It is not allowed to do any changes on the seat or the belts.
• Each change of any part of the seat, which is not done by the manufacturer, will cause
the expiration of the ECE- approval and excludes immediately any warranties.
• Should any doubts occur, contact your supplier or HEYNER MOBIL AUTOMOTIVE GMBH
• After an accident, the entire child restraint system should be replaced or at least sent
to the manufacturer for inspection, together with the accident report.
This service cost will be charged.
c -capsula.com
English
D
GB
28