If the alarm forwarding has already taken
place in a radio group, and you cannot
identify the alarm-triggering device, pro-
ceed as follows:
(1) Press the testing / stop button on a
device of a subgroup or shared radio
group.
(2) Alarm of the forwarding devices of
this group is stopped.
(3) Follow the same procedure for
other groups.
The alarm of the alarm-triggering
device can only be terminated
directly on the device in question.
Thus the fire location can be
located in case of fire.
(4) Press the testing / stop button on
the device triggering the alarm.
5 Alarm on the triggering device and
forwarding devices is stopped.
EN
EN
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
7 Fault and error
messages
The device automatically checks its opera-
tional readiness once a minute. The device
displays functional limitations in the form
of error and alarm messages.
If the device detects environmental influ-
ences differing from the rule, it regulates
the sensitivity of its detection electronics
automatically.
7.1 Error messages
The following messages are considered
error messages:
Battery error message
•
Contamination message
•
Alarm without cause of fire
•
Defective connection test
•
of a radio group
71