pyrexx PX-IC Betriebsanleitung Seite 62

(3) Press firmly magnetic carrier for
about 10 seconds at the mounting
position.
(4) Taking the device into operation and
setting up.
f Observe chapter 6 "Putting into
operation and setup" on page 64.
(5) Put the device on the magnetic
carrier.
5 The device is mounted on the
magnetic carrier.
The ultimate strength of the ad-
hesive bond is achieved after
about 72 hours.
Adhesive mounting according
to EN 14604:2005/AC:2008
and vfdb 14/01 (Q)
To establish a permanent connection be-
tween the device and magnetic carrier
(e.g., as theft protection), you can addition-
ally mount the device with the supplied
adhesive film on the magnetic carrier.
62
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
CAUTION
Possible property damage!
The mounting of the device according
to vfdb 14/01 (Q) establishes a
permanent connection between the
magnetic carrier and the device. Thus,
a subsequent removal of the device
is prevented. It is difficult to carry out
maintenance. If the device is disassem-
bled, it can cause damage to the device
and the mounting surface.
f Use the additional adhesive film
only to prevent theft.
f Put the device in operation and
set it up before attaching the
additional adhesive film.
When performing this type of installation,
proceed as follows:
(1) Mount magnetic carrier.
f Observe chapter "Adhesive mounting
according to EN 14604:2005/AC:2008"
on page 61.
EN
EN