pyrexx PX-IC Betriebsanleitung Seite 66

6.3 Finalising radio group
In order to complete a newly established ra-
dio group, you must exit the learning mode.
You have two options for this purpose:
f Wait 10 minutes, or briefly press the
radio button on the device which was
last taken into operation until:
All signal LEDs "off"
5 Radio group is in operation.
f To verify, perform the connection
test (see chapter 6.6 "Group connec-
tion test" on page 68).
6.4 Bring the radio group into
learning mode
You can extend an existing radio group
by bringing the radio group in the learning
mode. Observe the following:
(1) Press and hold the radio button with
splint pin on any device until:
All signal LEDs "off"
66
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
(2) Release the radio button as soon as
the LED goes out.
5 Device max. 10 minutes in
learning mode.
(3) Add additional devices.
f Observe chapter 6.2 "Expand radio
group (learning mode)" on page 65.
6.5 Set up shared radio group
For special applications, it may be use-
ful to set up a shared radio group
(e.g., in the corridor of an apar tment
building). A central radio group (corridor),
which is associated with one or more oth-
er radio groups (flats), takes over the func-
tion of the shared radio group. The other
radio groups form subgroups.
EN
EN