Use
→ While the connection is being established, 3 beep signals sound and the
The
symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the prosthesis. This pro
cess may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component")
► Add the component again in the Cockpit app (see the section "Adding a component")
8.4.2 Deleting a component
1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the
symbol under the component you want to delete.
→ The component is deleted.
8.4.3 Connecting component with multiple devices
The connection for a component can be stored on more than one device. However, only one device or remote con
trol can be connected to the component at one time.
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
9 Use
9.1 Movement patterns in basic mode (mode 1)
9.1.1 Standing
Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled using the adjustment software. Please see the following
section for further information on the stance function.
9.1.1.1 Stance function
INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activated using the Cock
pit app or remote control (see Page 81).
The stance function (standing mode) is a functional supplement to the basic mode (mode 1). This function makes it
easier, for example, to stand on an inclined surface for a longer time. The joint is fixed in the flexion direction.
This function must be enabled in the adjustment software. Once the function is enabled, you can also choose
between an intuitive and a conscious lock.
74 | Ottobock
► Tap the OK button.
→ The connection to the last connected device is broken off and estab
lished with the current device.
OK
symbol appears.
Genium 3B1-2/3B1-2=ST