Cockpit App Navigation Menu; Managing Prostheses; Adding Component - Ottobock Genium 3B1-2 Gebrauchsanweisung

8.3.1 Cockpit app navigation menu

Product
MyModes
Functions
Settings
Status
General
Manage components
Imprint/Info

8.4 Managing prostheses

Connections with up to four different components can be stored in the app. However, a component can only be
connected to one device or remote control at a time.
The following points need to be observed before establishing the connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must
point up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth
on the prosthesis can be switched on permanently afterwards (see Page 82).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned off.
The device must be connected to the internet.
•
• The serial number and PIN code of the component being connected must be known. They are found on the
enclosed card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the PIN code and serial number of the component is lost, contact an authorised
Ottobock service centre. The serial number must be provided so a new card can be issued. This begins with the
letters SN and is found in the following position depending on the component:
Knee joints: On the inside of the frame.
Prosthetic feet: On the spherical cap.

8.4.1 Adding component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) In the following screen, tap the "Add component" button.
→ The "Preparation" screen appears. The serial number of the component should be entered here. The serial
number begins with the letters "SN".
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
Genium 3B1-2/3B1-2=ST
Tap the
settings for the connected component can be configured in this menu.
Product
Name of the connected component
change
MyModes
Return to the main menu to switch MyModes
2. Golf
Functions
Call up additional functions of the component (e.g. turn off Bluetooth) (see
Page 82)
Settings
Change settings of the currently selected mode (see Page 80)
Status
Query status of the connected component (see Page 83)
Manage components
Add or delete components (see Page 73)
Imprint/Info
Display information/legal notices for the cockpit app
symbol in the menus to display the navigation menu. Additional
Cockpit app
Ottobock | 73