Switching Mymodes Using Motion Patterns - Ottobock Genium 3B1-2 Gebrauchsanweisung

Product
1. Basic Mode 2. Golf
1
2
3
100% 1. Basic Mode

9.2.2 Switching MyModes using motion patterns

INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Switching using motion patterns has to be enabled in the adjustment software.
• Position the prosthetic leg back slightly and bounce on the forefoot while maintaining constant contact with the
floor.
• Weight must be placed on the forefoot while bouncing.
• The load may not be taken off the foot fully when relieving the load.
Switching process
à MyMode 1
3x
4x à MyMode 2
ð
1) Position the prosthetic leg back slightly.
2) While maintaining constant contact with the floor, bounce on the forefoot with the leg extended a number of
times in one second depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position with no load.
→ A beep and vibration signal will sound to confirm that the movement pattern has been recognised.
INFORMATION: If this beep and vibration signal does not sound, the requirements were not
observed when bouncing the foot or mute mode (silent mode) is activated. For more information
about mute mode, see the section "Mute mode" (see Page 84).
4) After the beep and vibration signal sounds, keep the prosthetic leg extended and still for 1 second.
Genium 3B1-2/3B1-2=ST
1) Tap the symbol of the MyMode (1) you want in the main menu of the
app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→ The current mode is also indicated by the name on the lower edge
of the screen (3).
1x
ð
+
1s
1x
ð ð
2x à MyMode 1
3x à MyMode 2
ð
MyMode 1
+
MyMode 2
Ottobock | 79
Use
þ