Parameter Input With Drivemonitor; Installation And Connection; Installation; Connection - Siemens SIMOVERT MASTERDRIVES Betriebsanleitung

Parameterization
8.5
NOTE
8.5.1
8.5.1.1
8.5.1.2
RS232 interface
NOTICE
8-14
Downloaded from www.Manualslib.com

Parameter input with DriveMonitor

Please refer to the online help for detailed information on
DriveMonitor (

Installation and connection

Installation

A DVD is included with the devices of the MASTERDRIVES Series
when they are delivered. The operating tool supplied on the DVD
(DriveMonitor) is automatically installed from this DVD. If "automatic
notification on change" is activated for the DVD drive on the PC, user
guidance starts when you insert the DVD and takes you through
installation of DriveMonitor. If this is not the case, start file
"Autoplay.exe" in the root directory of the DVD.

Connection

There are two ways of connecting a PC to a device of the SIMOVERT
MASTERDRIVES Series via the USS interface. The devices of the
SIMOVERT MASTERDRIVES Series have both an RS232 and an
RS485 interface.
The serial interface that PCs are equipped with by default functions as
an RS232 interface. This interface is not suitable for bus operation and
is therefore only intended for operation of a SIMOVERT
MASTERDRIVES device.
5
9
4
8
3
7
2
6
1
To PC COMx
socket
Fig. 8-5
DriveMonitor must not be operated via the Sub-D socket X300 if the
SST1 interface parallel to it is already being used for another purpose,
e.g. bus operation with SIMATIC as the master.
manuals search engine
button or F1 key).
Device side
-X300 (compact PLUS -X103)
9-pin SUB-D connector
Connecting cable for connecting PC COM(1-4) to SIMOVERT
MASTERDRIVES X300
Operating Instructions
08.2009
X300:
5
1 n.c. (not connected)
9
(Compact PLUS: RS232 Id)
4
2 RxD (RS232)
8
3 Rx+/Tx+ (RS485)
3
4
7
2 5 Ground
6
6 +5V (OP1S)
1
7 TxD (RS232)
8 Rx-/Tx- (RS485)
9 Ground
6SE7087-6JD50 Siemens AG
SIMOVERT MASTERDRIVES