Siemens SIMOVERT MASTERDRIVES Betriebsanleitung Seite 194

Connecting-up
Maximum
connectable cross-
sections, screw
connection,
tightening torque
X1 – Mains
connection, DC link
connection
U1 V1 W1 PE1 C
L1 L2 L3
X2 – Motor
connection
T1 T2 T3
U2 V2 W2 PE2
7-6
Downloaded from www.Manualslib.com
Type Order number
A 6SE702_-__A__
B 6SE702_-__B__
C 6SE702_-__C__
D 6SE702_-__D__
Table 7-2
The mains and DC link connections are located on the top section of
the unit on a joint terminal block.
Terminal
1
2
D
3
L+ L-
4
5
6
Terminal 1 is at the left when installed.
Table 7-3
The motor connection is located at the bottom of the unit.
Terminal
1
2
3
4
Terminal 1 is at the left when installed.
Table 7-4
manuals search engine
Finely-stranded
mm² AWG
1.5 to 10 12 to 6
1.5 to 10 12 to 6
4 to 16 10 to 4
10 to 35 6 to 2
Maximum connectable cross-sections
Designation Meaning
U1 / L1 Phase U1 / L1
V1 / L2 Phase V1 / L2
W1 / L3 Phase W1 / L3
PE1 Protective conductor
connection
C / L+ DC link voltage +
D / L- DC link voltage -
Mains, DC link connection
Designation Meaning
U2 / T1 Phase U2 / T1
V2 / T2 Phase V2 / T2
W2 / T3 Phase W2 / T3
Protective conductor
PE2
connection
Motor connection
Operating Instructions
08.2009
Multi-stranded, Tightening
solid torque
mm² AWG Nm
2.5 to 16 12 to 4 2
2.5 to 16 12 to 4 2
10 to 25 6 to 2 2
10 to 50 6 to 0 3.5
Range
3AC 380 - 480 V
3AC 380 - 480 V
3AC 380 - 480 V
DC 510 - 650 V
DC 510 - 650 V
Range
3AC 0 - 480 V
3AC 0 - 480 V
3AC 0 - 480 V
6SE7087-6JD50 Siemens AG
SIMOVERT MASTERDRIVES