Siemens SIMOVERT MASTERDRIVES Betriebsanleitung Seite 299

08.2009
Number / Alarm
A082
CB alarm
A083
CB alarm
A084
CB alarm
A085
CB alarm
A086
CB alarm
A087
CB alarm
A088
CB alarm
A089
CB alarm
A090
CB alarm
A091
CB alarm
A092
CB alarm
Siemens AG
SIMOVERT MASTERDRIVES
Downloaded from www.Manualslib.com
Cause
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
No valid PPO type can be identified from the
configuration telegram of the DP master.
Consequence:
No connection is made with the PROFIBUS
master.
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
No net data or invalid net data (e.g. complete
control word STW1=0) are being received
from the DP master.
Consequence:
The process data are not passed on to the
dual port RAM. If P722 (P695) is not equal to
zero, this will cause the fault message F082 to
be tripped.
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
The telegram traffic between the DP master
and the CBP has been interrupted (e.g. cable
break, bus cable pulled out or DP master
powered down).
Consequence:
If P722 (P695) is not equal to zero, this will
cause the fault message F082 to be tripped.
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
The CBP does not generate this alarm!
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
Failure of the heartbeat counter on the basic
unit. The heartbeat counter on the basic unit is
no longer being incremented. The
communication between the CBP and the
basic board is disturbed.
The following description refers to the 1st
CBP. For other CBs or the TB see the
operating instructions for the CB board.
Fault in the DPS manager software of the
CBP.
See user manual for CB board
See user manual for CB board
Alarm of the 2nd CB board corresponds to
A81 of the 1st CB board
See user manual for CB board
Alarm of the 2nd CB board corresponds to
A82 of the 1st CB board
See user manual for CB board
Alarm of the 2nd CB board corresponds to
A83 of the 1st CB board
See user manual for CB board
Alarm of the 2nd CB board corresponds to
A84 of the 1st CB board
Siemens Controls
6SE7087-6JD50
Operating Instructions
manuals search engine
Faults and Alarms
Counter-measure
New configuration necessary.
See operating instructions of the CB board
See operating instructions of the CB board
See operating instructions of the CB board
See operating instructions of the CB board
See operating instructions of the CB board
See user manual for CB board
See user manual for CB board
See user manual for CB board
See user manual for CB board
See user manual for CB board
12-17