General Safety Instructions; Instructions For Use (User); Scope Of Delivery - Ottobock C-Leg Protector 4X860 Gebrauchsanweisung (Benutzer

> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
► This symbol identifies activities/actions that must be observed/carried out in order to avert
the hazard.

4.3 General Safety Instructions

NOTICE
Changes or modifications to the product made independently
Damage to the product.
► Have any changes or modifications to the product carried out only by authorised, qualified
personnel.
CAUTION
Penetration of dirt and humidity into the prosthesis
Injury due to unexpected prosthesis behaviour or malfunction.
► Should moisture have penetrated the prosthesis, remove the product from the prosthesis
and allow both to dry. Observe the safety information in the 646D790 C-Leg instructions for
use.
► The product and the prosthesis must be inspected by an authorised Ottobock Service
Centre.

5 Scope of delivery

Scope of delivery for 4X860=*
• 1 pc. C-Leg Protector main unit (without shield insert)
• 1 pc. 4P860=R lengthwise closure
• 1 pc. 4P860=U upper closure
• 1 pc. 4P880=* Protector Foot Cuff
• 1 pc. 647G1114 instructions for use (user)
The following components are not included in the scope of delivery and must be ordered separ­
ately:
Accessories
• 1 pc. 4P863=* shield insert
6 Handling
INFORMATION
Removing the foot cuff from the prosthetic foot is not possible. The foot cuff stays on the pros­
thetic foot even when the protector is not being used.
6.1 Protector Installation
NOTICE
Loss of stability due to inadequately installed retainers
No hold of the protector on the knee joint.
► Ensure that all retainers and closures are properly engaged and/or fastened.
1) Open or remove the closures.
2) Spread open the protector.
10 | Ottobock