MAXA FD2M42R Bedienungs- & Installationsanleitung Seite 60

Model E
Model G
CAUTION
After confirmation of the above conditions, follow these guidelines when performing wiring:
・ Always have an individual power circuit specifically for the air conditioner. Always follow the
circuit diagram posted on the inside of the control cover.
・ Screws fastening the wiring in the casing of electrical fittings may come loose during
transporation. Because loose screws may cause wire burn-ou, check that the screws are tightly
fastened.
・ Check the specifications for the power source.
・ Confirm that electrical capacity is sufficient.
・ Confirm that starting voltage is maintained at more than 90 percent of the rated voltage
marked on the name plate.
・ Confirm that the cable thickness is as specified in the power source specifications.
・ Always install an earth leakage circuit breaker in wet or moist areas.
・The following can be caused by a drop in voltage: vibration of a magnetic switch, damaging
the contact point, broken fuses, and disturbance of normal functioning.
・ Disconnection from a power supply must be incorporated into the fixed wiring. It must have
an air gap contact separation of at least 3mm in each active (phase) conductors.
・ Before accessing terminals, all supply circuits must be disconnected.
Model F

Page 20
