alfen Eve Single Pro-line Bedienungsanleitung Seite 33

If the functionality was purchased. The charging station will not be part of the SCN if you have not purchased this
functionality. After you receive confirmation for your purchase of this functionality by Alfen, the new functionality can be
downloaded using the Service Installer application.
NOTICE!
After setting up a Smart Charging Network, all newly added charging stations will need to reboot. After rebooting, the
charging stations will log in to the Smart Charging Network.
About OCPP
The functionalities of the SCN are available through the UTP/Ethernet connection of the charging stations. This can easily
be combined with communication over OCPP, through UTP/Ethernet or GPRS. Note that you need one SIM card per charging
station. To limit costs, you can also use a router and a (2G/3G/4G) modem. In that case, the charging stations should be set
to communicate with a wired network. The router is then set for the (secure) APN of the relevant management system.
How to set up
Network choice
Smart Charging Network with OCPP GPRS
Smart Charging Network with OCPP GPRS
Smart Charging Network with OCPP through
external GPRS router
Electrical supply (local installation)
Settings
REMARK
Want to know more about the Smart Charging Network? Contact our Sales department or
Sales Support via cpadmin@alfen.com
Eve Single Pro-line DE manual | Version 1.0 | February 2020
APPENDIX B: DEFAULT SELECTIONS FOR
OPTIONAL FACTORY SETTINGS
Per charging station
SCN ON
SCN ON
SCN ON
See paragraphs 2.5.11 and 2.5.12, always set to full power per charging
station.
Factory settings: set for charging station (max output)
OCPP settings
OCPP Management System Selection
for GPRS
OCPP Management System selection for UTP
OCPP Management System selection for UTP
33