Personnel Qualifications; Electrical Work; Monitoring Devices - Wilo Padus PRO Einbau- Und Betriebsanleitung

2.2

Personnel qualifications

2.3

Electrical work

2.4

Monitoring devices

Installation and operating instructions Wilo-Padus PRO
Safety
Personal protective equipment: wear foot protection
Personal protective equipment: wear hand protection
Personal protective equipment: wear mouth protection
Personal protective equipment: wear safety goggles
Working alone is prohibited! A second person must be present.
Useful information
Personnel must:
▪ Be instructed about locally applicable regulations governing accident prevention.
▪ Have read and understood the installation and operating instructions.
Personnel must have the following qualifications.
▪ Electrical work: A qualified electrician must carry out the electrical work.
▪ Installation/dismantling: The technician must be trained in the use of the necessary
tools and fixation materials for the relevant construction site.
▪ Maintenance tasks: The technician must be familiar with the use of operating fluids and
their disposal. In addition, the technician must have basic knowledge of mechanical en-
gineering.
Definition of "qualified electrician"
A qualified electrician is a person with appropriate technical education, knowledge and
experience who can identify and prevent electrical hazards.
▪ Electrical work must be carried out by a qualified electrician.
▪ Before commencing work, disconnect the product from the mains and secure it against
being switched on again.
▪ Observe applicable local regulations when connecting to the mains power supply.
▪ Comply with the requirements of the local energy supply company.
▪ Train personnel in how to make electrical connections.
▪ Instruct personnel in the methods to switch off the device.
▪ Observe the technical information in these installation and operating instructions as
well as on the rating plate.
▪ Earth the device.
▪ Observe regulations for connection to the electrical switching system.
▪ It is not possible to connect the device to electronic start-up controllers (e.g. soft
starter or frequency converter).
▪ Replace defective connection cables. Contact customer service.
The following monitoring devices must be provided on-site:
Circuit breaker
The size and switching characteristics of the circuit breakers must conform to the rated
current of the connected product. Observe local regulations.
Motor protection switch
Make provision for an on-site motor protection switch for devices without a plug! The
minimum requirement is a thermal relay/motor protection switch with temperature
compensation, differential triggering and anti-reactivation device in accordance with
the local regulations. In case of sensitive mains, make provision for the installation on-
site of other protective equipment (e.g. overvoltage, undervoltage or phase failure re-
lay, etc.).
en
37